Irish Road Haulage, Transport & Commercial Vehicle News

Ireland’s Leading News & Information Hub for the Road Haulage Industry

EU truck-weight talks postponed as payload issues remain unresolved

Negotiations on new EU truck weight and dimension rules have been postponed, prolonging uncertainty over 44-tonne cross-border operations and the payload available to battery-electric and hydrogen trucks.

The next trilogue—a negotiation involving the European Parliament, Council and Commission—was due to take place on 10 November 2026. It has now been pushed back until no earlier than late November, while a preparatory discussion involving Member State representatives was also rescheduled.

The delay does not alter the rules currently applying to Irish trucks. The revised Weights and Dimensions Directive remains a proposal, and none of the disputed new weight allowances can be used until a final agreement is adopted and implemented.

Why are the negotiations proving difficult?

The directive sets common maximum dimensions for heavy commercial vehicles and maximum weights for trucks engaged in international EU transport.

Its revision is intended to accommodate zero-emission powertrains, improve cross-border consistency and permit more efficient use of longer or heavier vehicle combinations.

However, negotiators remain divided over three major issues.

Additional weight for zero-emission trucks

Battery packs, hydrogen tanks and associated equipment can make a zero-emission tractor substantially heavier than a diesel equivalent.

The Commission proposed additional weight allowances to prevent that extra technology reducing freight payload. The Council supports a weight bonus but wants different allowances for five- and six-axle combinations to limit damage to roads and bridges.

Truck manufacturers argue that increasing the gross combination weight will not be enough if the tractor’s drive axle remains restricted. They are particularly concerned about common two-axle 4×2 tractors, where battery weight can consume axle capacity before the combination reaches its maximum permitted gross weight.

ACEA says inadequate axle and gross-weight allowances could leave electric trucks carrying less freight than equivalent diesel vehicles. That remains an industry position rather than an agreed finding.

Cross-border operation at 44 tonnes

Several EU countries permit 44-tonne combinations domestically, but the same vehicle may have to reduce its weight when crossing a border.

Transport organisations want combinations that are legal at 44 tonnes in both neighbouring Member States to be allowed to cross between them at that weight.

This remains unresolved. France has reportedly expressed particular concern about a wider cross-border entitlement, while haulier and logistics organisations argue that inconsistent limits create additional journeys, costs and emissions.

Longer and heavier vehicle combinations

Negotiators have made progress on European Modular Systems—vehicle combinations that can weigh 60 tonnes or more.

A provisional understanding would allow cross-border operation between neighbouring Member States that both authorise these combinations, provided their respective national weight and length restrictions are respected. Individual countries would retain the right to decide whether to permit the vehicles domestically.

Infrastructure assessment would also be required before new trials, which could run for up to seven years. This element is not final until the complete directive is agreed.

Why it matters to Irish hauliers

The most immediate Irish concern is electric-truck payload.

Operators carrying beverages, food ingredients, construction materials or other dense freight need to know whether a zero-emission truck can carry the same commercial load as a diesel vehicle without breaching gross or individual axle limits.

Cross-border harmonisation also matters to international fleets. Irish trucks operating through several EU countries need clear, consistent rules rather than different national interpretations at each border.

Fleet buyers should therefore ask manufacturers for the precise unladen weight, legal drive-axle loading and usable payload of the exact vehicle specification being considered—not simply its headline maximum combination weight.

The postponement means those answers will remain partly dependent on unfinished legislation. Negotiations are expected to resume no earlier than late November, but there is no guarantee that a final agreement will be reached before the end of 2026.

FTA Ireland
Register Now

SHARE:

Facebook
Twitter
LinkedIn
RELATED NEWS